Furnace igniter or flame sensor cost in Kansas
Modeled · v0.1 · method published · independent of contractors
In Kansas, a fair price for furnace igniter or flame sensor is $130–$330 (per repair), with a typical price of $220. That's 10% below the national typical of $245, reflecting Kansas's regional cost index of 0.89.
Kansas ranks #43 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Kansas | $130 | $220 | $330 |
| National | $145 | $245 | $370 |
| Kentucky | $130 | $220 | $330 |
| South Dakota | $130 | $220 | $330 |
| Iowa | $130 | $220 | $335 |
| Louisiana | $130 | $220 | $335 |
Other HVAC jobs in Kansas
- Condenser fan motor replacement: $430 typical
- Run capacitor replacement: $190 typical
- 3-ton system replacement: $7,920 typical
- HVAC diagnostic / service call: $135 typical
- AC or furnace tune-up: $125 typical
- Condensate drain line clear or repair: $175 typical
- Gas furnace replacement, 80k BTU: $4,810 typical
- Reconnect or seal disconnected duct: $265 typical
- Dryer vent cleaning: $135 typical
- Dryer vent reroute or replacement: $425 typical
- AC contactor replacement: $200 typical
- Thermostat replacement: $270 typical
- Furnace blower motor replacement: $525 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Kansas, or see how these prices are calculated.