Furnace igniter or flame sensor cost in Nebraska
Modeled · v0.1 · method published · independent of contractors
In Nebraska, a fair price for furnace igniter or flame sensor is $135–$340 (per repair), with a typical price of $225. That's 8% below the national typical of $245, reflecting Nebraska's regional cost index of 0.91.
Nebraska ranks #38 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Nebraska | $135 | $225 | $340 |
| National | $145 | $245 | $370 |
| Missouri | $135 | $225 | $340 |
| Tennessee | $135 | $225 | $340 |
| New Mexico | $135 | $225 | $340 |
| South Carolina | $135 | $225 | $340 |
Other HVAC jobs in Nebraska
- Condenser fan motor replacement: $440 typical
- Run capacitor replacement: $195 typical
- 3-ton system replacement: $8,100 typical
- HVAC diagnostic / service call: $135 typical
- AC or furnace tune-up: $125 typical
- Condensate drain line clear or repair: $175 typical
- Gas furnace replacement, 80k BTU: $4,910 typical
- Reconnect or seal disconnected duct: $275 typical
- Dryer vent cleaning: $135 typical
- Dryer vent reroute or replacement: $430 typical
- AC contactor replacement: $205 typical
- Thermostat replacement: $280 typical
- Furnace blower motor replacement: $535 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Nebraska, or see how these prices are calculated.