Furnace igniter or flame sensor cost in Oregon
Modeled · v0.1 · method published · independent of contractors
In Oregon, a fair price for furnace igniter or flame sensor is $160–$405 (per repair), with a typical price of $265. That's 8% above the national typical of $245, reflecting Oregon's regional cost index of 1.09.
Oregon ranks #14 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Oregon | $160 | $265 | $405 |
| National | $145 | $245 | $370 |
| Maryland | $160 | $265 | $405 |
| Colorado | $160 | $265 | $400 |
| New Hampshire | $160 | $265 | $400 |
| Rhode Island | $165 | $275 | $415 |
Other HVAC jobs in Oregon
- Condenser fan motor replacement: $525 typical
- Run capacitor replacement: $235 typical
- 3-ton system replacement: $9,700 typical
- HVAC diagnostic / service call: $165 typical
- AC or furnace tune-up: $155 typical
- Condensate drain line clear or repair: $215 typical
- Gas furnace replacement, 80k BTU: $5,890 typical
- Reconnect or seal disconnected duct: $325 typical
- Dryer vent cleaning: $165 typical
- Dryer vent reroute or replacement: $520 typical
- AC contactor replacement: $245 typical
- Thermostat replacement: $330 typical
- Furnace blower motor replacement: $645 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Oregon, or see how these prices are calculated.