Furnace igniter or flame sensor cost in Texas
Modeled · v0.1 · method published · independent of contractors
In Texas, a fair price for furnace igniter or flame sensor is $140–$355 (per repair), with a typical price of $235. That's 4% below the national typical of $245, reflecting Texas's regional cost index of 0.95.
Texas ranks #32 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Texas | $140 | $235 | $355 |
| National | $145 | $245 | $370 |
| Idaho | $140 | $235 | $355 |
| North Carolina | $140 | $235 | $355 |
| North Dakota | $140 | $235 | $355 |
| Montana | $140 | $235 | $355 |
Other HVAC jobs in Texas
- Condenser fan motor replacement: $460 typical
- Run capacitor replacement: $205 typical
- 3-ton system replacement: $8,460 typical
- HVAC diagnostic / service call: $145 typical
- AC or furnace tune-up: $135 typical
- Condensate drain line clear or repair: $185 typical
- Gas furnace replacement, 80k BTU: $5,130 typical
- Reconnect or seal disconnected duct: $285 typical
- Dryer vent cleaning: $145 typical
- Dryer vent reroute or replacement: $450 typical
- AC contactor replacement: $215 typical
- Thermostat replacement: $290 typical
- Furnace blower motor replacement: $560 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Texas, or see how these prices are calculated.