Furnace igniter or flame sensor cost in Arizona
Modeled · v0.1 · method published · independent of contractors
In Arizona, a fair price for furnace igniter or flame sensor is $145–$365 (per repair), with a typical price of $240. That's 2% below the national typical of $245, reflecting Arizona's regional cost index of 0.98.
Arizona ranks #26 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Arizona | $145 | $240 | $365 |
| National | $145 | $245 | $370 |
| Florida | $145 | $245 | $370 |
| Wisconsin | $145 | $245 | $370 |
| Michigan | $145 | $240 | $360 |
| Utah | $145 | $245 | $370 |
Other HVAC jobs in Arizona
- Condenser fan motor replacement: $470 typical
- Run capacitor replacement: $210 typical
- 3-ton system replacement: $8,720 typical
- HVAC diagnostic / service call: $145 typical
- AC or furnace tune-up: $135 typical
- Condensate drain line clear or repair: $190 typical
- Gas furnace replacement, 80k BTU: $5,290 typical
- Reconnect or seal disconnected duct: $295 typical
- Dryer vent cleaning: $145 typical
- Dryer vent reroute or replacement: $465 typical
- AC contactor replacement: $220 typical
- Thermostat replacement: $300 typical
- Furnace blower motor replacement: $580 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Arizona, or see how these prices are calculated.