Furnace igniter or flame sensor cost in Wisconsin
Modeled · v0.1 · method published · independent of contractors
In Wisconsin, a fair price for furnace igniter or flame sensor is $145–$370 (per repair), with a typical price of $245. That's about the same as the national typical of $245, reflecting Wisconsin's regional cost index of 0.99.
Wisconsin ranks #25 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Wisconsin | $145 | $245 | $370 |
| National | $145 | $245 | $370 |
| Florida | $145 | $245 | $370 |
| Utah | $145 | $245 | $370 |
| Arizona | $145 | $240 | $365 |
| Maine | $150 | $245 | $375 |
Other HVAC jobs in Wisconsin
- Condenser fan motor replacement: $475 typical
- Run capacitor replacement: $215 typical
- 3-ton system replacement: $8,810 typical
- HVAC diagnostic / service call: $150 typical
- AC or furnace tune-up: $140 typical
- Condensate drain line clear or repair: $195 typical
- Gas furnace replacement, 80k BTU: $5,350 typical
- Reconnect or seal disconnected duct: $295 typical
- Dryer vent cleaning: $150 typical
- Dryer vent reroute or replacement: $470 typical
- AC contactor replacement: $225 typical
- Thermostat replacement: $300 typical
- Furnace blower motor replacement: $585 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Wisconsin, or see how these prices are calculated.