Furnace igniter or flame sensor cost in Connecticut
Modeled · v0.1 · method published · independent of contractors
In Connecticut, a fair price for furnace igniter or flame sensor is $170–$430 (per repair), with a typical price of $285. That's 16% above the national typical of $245, reflecting Connecticut's regional cost index of 1.16.
Connecticut ranks #8 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Connecticut | $170 | $285 | $430 |
| National | $145 | $245 | $370 |
| Washington | $170 | $280 | $430 |
| New Jersey | $175 | $290 | $440 |
| Rhode Island | $165 | $275 | $415 |
| Massachusetts | $180 | $300 | $455 |
Other HVAC jobs in Connecticut
- Condenser fan motor replacement: $560 typical
- Run capacitor replacement: $250 typical
- 3-ton system replacement: $10,300 typical
- HVAC diagnostic / service call: $175 typical
- AC or furnace tune-up: $160 typical
- Condensate drain line clear or repair: $225 typical
- Gas furnace replacement, 80k BTU: $6,260 typical
- Reconnect or seal disconnected duct: $350 typical
- Dryer vent cleaning: $175 typical
- Dryer vent reroute or replacement: $550 typical
- AC contactor replacement: $260 typical
- Thermostat replacement: $355 typical
- Furnace blower motor replacement: $685 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Connecticut, or see how these prices are calculated.