Furnace igniter or flame sensor cost in Washington
Modeled · v0.1 · method published · independent of contractors
In Washington, a fair price for furnace igniter or flame sensor is $170–$430 (per repair), with a typical price of $280. That's 14% above the national typical of $245, reflecting Washington's regional cost index of 1.15.
Washington ranks #9 of 51 for this job, where #1 is the most expensive.
Compared with similar-cost states
| Where | Low | Typical | High |
|---|---|---|---|
| Washington | $170 | $280 | $430 |
| National | $145 | $245 | $370 |
| Connecticut | $170 | $285 | $430 |
| Rhode Island | $165 | $275 | $415 |
| New Jersey | $175 | $290 | $440 |
| Maryland | $160 | $265 | $405 |
Other HVAC jobs in Washington
- Condenser fan motor replacement: $555 typical
- Run capacitor replacement: $245 typical
- 3-ton system replacement: $10,250 typical
- HVAC diagnostic / service call: $175 typical
- AC or furnace tune-up: $160 typical
- Condensate drain line clear or repair: $225 typical
- Gas furnace replacement, 80k BTU: $6,210 typical
- Reconnect or seal disconnected duct: $345 typical
- Dryer vent cleaning: $175 typical
- Dryer vent reroute or replacement: $545 typical
- AC contactor replacement: $260 typical
- Thermostat replacement: $350 typical
- Furnace blower motor replacement: $680 typical
Got a quote?
Check it against these ranges with the free lookup on the homepage, browse the furnace igniter or flame sensor prices in every state, read the HVAC guide, see every job priced for Washington, or see how these prices are calculated.